If you’d like to assign your own IP, feel free to unquote the “//IPAddress ip(190, 160, 0, 50) ” and “ //nfig(ip) ” lines respectively. (make sure DHCP is enabled on your router) I’ve quoted out the IPAddress for now so your router can assign an IP address for you.
#HEAR 1.0.3 SERIAL NUMBER PASSWORD#
Upload the following sketch making sure you change the SSID and insert your password to fit your wireless network settings.
Re-connect your shield to the Arduino and plug in to PC via USB. If all jobs have passed, reset your shield by pressing it’s reset button and then continue to the next command : batchisp.exe -device AT32UC3A1256 -hardware usb -operation erase f memory flash blankcheck loadbuffer c:\wifiHD.elf program verify start reset 0 cd C:\Program Files (x86)\Atmel\Flip 3.4.7\bin) and execute the following command: batchisp.exe -device AT32UC3A1256 -hardware usb -operation erase f memory flash blankcheck loadbuffer c:\wifi_dnld.elf program verify start reset 0Ĭheck if all jobs have passed. In the command prompt, change directories to the path where you’ve installed the FLIP package (i.e. Next, unplug the Wifi shield from the Arduino and short out the jumper on the Wifi board to put it into programming mode.Ĭonnect the shield to your PC via USB and then start up a command prompt. I assume you have already downloaded the FLIP package from the Atmel page here: Please download the 2 firmware files I’ve attached and save them to the root of your C drive. With some of these things, it’s probably best to start at the beginning so let’s do this